INTERVIEW QUESTIONS COMPUTER HARDWARE 8085 DETAILS

Question: Can an RC circuit be used as clock source for 8085?

Answer: Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal.

Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal. Source: CoolInterview.com

Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal. Source: CoolInterview.com

yes it can be used,if an accurate clock frequency is not requried.Also,the component cost is low compared to LC or crystal
Source: CoolInterview.com

yes it can be used,if an accurate clock frequency is not requried.Also,the component cost is low compared to LC or crystal Source: CoolInterview.com

Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal.


Source: CoolInterview.com

yes it can be used,if an accurate clock frequency is not required.Also,the component cost is low compared to LC or crystal Source: CoolInterview.com

i like this type of site Source: CoolInterview.com

ya it can be used as clock source.
one important advantage of RC clock is that it can avoid RACE AROUND condition by producing sharp edged pulses. Source: CoolInterview.com

ya it can be used as clock source.
one important advantage of RC clock is that it can avoid RACE AROUND condition by producing sharp edged pulses. Source: CoolInterview.com

If you have the better answer, then send it to us. We will display your answer after the approval.

Rules to Post Answers in CoolInterview.com:-

• There should not be any Spelling Mistakes.
• There should not be any Gramatical Errors.
• Answers must not contain any bad words.
• Answers should not be the repeat of same answer, already approved.
• Answer should be complete in itself.

Name :*
Email Id :*
Answer :*
Verification Code	Not readable? Load New Code
Enter the above shown code: *
	Inform me about updated answers to this question