|
Related Questions |
View Answer |
|
An installed z/OS customer also has Power6 Servers. They are investigating consolidation of both types of servers to z/OS. Which of the following will establish the capacity for a new z/OS server?
A. AD Tools B. Estimate the AIX load and add to CP3000 results. C. CP3000 D. Run AIX in a z/OS LPAR to establish the loadWArialTimes New RomanZ
|
View Answer
|
|
A System z customer has a new CIO. The CIO is concerned about continuing operations and recovery following a catastrophe. Which of the following addresses this issue?
A. GDPS B. TAM C. DR D. WAS
|
View Answer
|
|
A z10 customer has numerous Unix servers, a large number of Windows servers, and an unidentified number of small department servers that were acquired outside of IT influence. The CIO wants to know how much they are currently spending on IT company wide and determine if software licenses are managed correctly. Which of the following approaches would provide that information?
A. Perform a TCO analysis B. An internal review, department by department C. Review of IT department expense items D. Interview all department heads
|
View Answer
|
|
What is a requirement to connect a V6R1 IBM i host to an XIV Storage System?
A. XIV firmware V10.0.8 B. Host Attachment Kit V1.0.1 C. SAN Volume Controller (SVC)V4.2 D. Virtual I/O Server (VIOS) V2.1.1
|
View Answer
|
|
Question: 8 What help ensure that the XIV System's cache does not become a bottleneck?
A. central cache locking mechanism B. use of industry standard chip technology C. each module is responsible for caching the data in that module D. having all modules understand what is held cache at all times
Answer: C
|
View Answer
|
|
When using the SAN Volume Controller (SVC) as a host for a full 15 module XIV Storage System, how many ports are recommended to be connected to the SVC?
A. 8 B. 12 C. 16 D. 24
|
View Answer
|
|
A customer has ordered a 10 module XIV System. How many interface modules are active in this configuration?
A. 3 B. 4 C. 5 D. 6
|
View Answer
|
|
On the XIV System, what is the approximate rebuild time for a 1 TB drive that is 50% utilized?
A. 5 minutes B. 15 minutes C. 30 minutes D. 120 minutes
|
View Answer
|
|
When defining a volume on a thin-provisioned pool on an XIV System, the size of the volume is limited by
A. the hard capacity of the volume B. the 2 TB maximum volume size on XIV C. the hard capacity of the storage pool D. the soft capacity of the storage pool
|
View Answer
|
|
Which two solutions, once installed and configured, can be used to move workloads without disruption? (Choose two)
A. XIV partitions B. XIV Data Mover (XDM) C. SAN Volume Controller D. XIV Data Migration Function E. Tivoli Storage Productivity Center for Replication V4
|
View Answer
|
|
To improve system redundancy using its grid architecture, where in the XIV System can a partition be mirrored?
A. on disks in other modules B. on same disk in different modules C. on different disks in the same module D. on same disk, in same module, and in different modules
|
View Answer
|
|
Using the XCLI, which qualifiers are required to create a thin provisioned pool?
A. pool, hard size, soft size, snapshot size B. pool, hard size, soft size, read block behavior C. pool, resize allowed, maximum volumes, maximum snapshots D. pool, read block behavior, maximum volumes, maximum snapshots
|
View Answer
|