INTERVIEW QUESTIONS SCIENCE BIOLOGY DETAILS

Question: Why does DNA twist?

Answer: If it did not twist, would you expect it to fit into the miniscule cell? As we all know, if we join all of the DNA molecules from a person's body end to end, we would get length three times the distance from the centre of the earth to the sun! Therefore, DNA does not have a choice but to follow the super solenoid structure. This is also aided by the purine-pyrimidine linkages, to balance the weight of DNA components. Why pressing down on the cover slip does not remove excess water. Because of Newton's Third Law of Motion: Every action has an equal an opposite reaction and hydraulic pressure. When you press down on the cover slip, the water underneath it pushes back against you with the same force that you are pressing down on it. If you want to get the water to move out from under the cover slip, you need to direct it to the side. One way to do this is to lift an edge and break the suction, then set it back down on one edge first to let the water run out, then press it down. This creates a side motion so the water does not push straight up into the cover slip, but pushes at an angle, which allows it to run out.

If it did not twist, would you expect it to fit into the miniscule cell? As we all know, if we join all of the DNA molecules from a person's body end to end, we would get length three times the distance from the centre of the earth to the sun! Therefore, DNA does not have a choice but to follow the super solenoid structure. This is also aided by the purine-pyrimidine linkages, to balance the weight of DNA components. Why pressing down on the cover slip does not remove excess water. Because of Newton's Third Law of Motion: Every action has an equal an opposite reaction and hydraulic pressure. When you press down on the cover slip, the water underneath it pushes back against you with the same force that you are pressing down on it. If you want to get the water to move out from under the cover slip, you need to direct it to the side. One way to do this is to lift an edge and break the suction, then set it back down on one edge first to let the water run out, then press it down. This creates a side motion so the water does not push straight up into the cover slip, but pushes at an angle, which allows it to run out. Source: CoolInterview.com

If you have the better answer, then send it to us. We will display your answer after the approval.

Rules to Post Answers in CoolInterview.com:-

• There should not be any Spelling Mistakes.
• There should not be any Gramatical Errors.
• Answers must not contain any bad words.
• Answers should not be the repeat of same answer, already approved.
• Answer should be complete in itself.

Name :*
Email Id :*
Answer :*
Verification Code	Not readable? Load New Code
Enter the above shown code: *
	Inform me about updated answers to this question