INTERVIEW QUESTIONS SAP R/3 SAP MM DETAILS

Question: We have defined all the variables for the materials. However, when I attempt to use Material Matchcode object MAT1, I get the response "No possible entries found". Why?

Answer: Matchcode i.d. "B", "Material by bill of material" has a selection condition for field STLNR NE ' '. STLNR is the BOM number associated with a material in table MAST. Hence the message - "no possible entries..." pops up if there are no bills of materials associated with your material numbers. You get the matchcodes as long as the material referred by you has BOM number associated with it.

Matchcode i.d. "B", "Material by bill of material" has a selection condition for field STLNR NE ' '. STLNR is the BOM number associated with a material in table MAST. Hence the message - "no possible entries..." pops up if there are no bills of materials associated with your material numbers. You get the matchcodes as long as the material referred by you has BOM number associated with it. Source: CoolInterview.com

If you have the better answer, then send it to us. We will display your answer after the approval.

Rules to Post Answers in CoolInterview.com:-

• There should not be any Spelling Mistakes.
• There should not be any Gramatical Errors.
• Answers must not contain any bad words.
• Answers should not be the repeat of same answer, already approved.
• Answer should be complete in itself.

Name :*
Email Id :*
Answer :*
Verification Code	Not readable? Load New Code
Enter the above shown code: *
	Inform me about updated answers to this question